Home Images Gallery for Your Collections

Roof-wall-interface, designing for optimum performance. introduction. the roof to wall interface remains a unique often ill conceived component of the building enclosure. it must protect, perform, and prevail in the face of extreme events as well as normally anticipated exposure to the environment.. Roof/ wall interface detail. roofing shingles membrane type eave protection (48" high min.) 1/2" plywood sheathing c/w h clips pre-engineered raised heel wood trusses (preferred) r-40 insulation 3/4" x 3" wood furring air & vapor retarder 1/2" gypsum board *seal all tyvek®joints and penetrations with approved tape., 01.030.0831: roof-wall interface detail - anchored brick veneer, cmu backing. this detail illustrates a low roof terminating into a higher wall. the tall interior single-wythe cmu wall transitions into an anchored veneer wall above the roof line. the open web steel joists of the roof structure bear on the tall cmu wall via a steel bearing plate on a cmu bond beam. the roof system terminates ....

Roof/ wall interface detail (heating climate) title: a65 created date: 6/24/2013 9:31:02 am ..., 01.030.0831: roof-wall interface detail – anchored brick veneer, cmu backing this detail illustrates a low roof terminating into a higher wall. the tall interior single-wythe cmu wall transitions into an anchored veneer wall above the roof line. the open web steel joists of the roof structure bear on the tall cmu wall via a steel….

01.030.0831 roof-wall interface | anchored brick veneer, cmu backing. this detail illustrates a low roof terminating into a higher wall, the tall interior single-wythe cmu wall transitions into an anchored veneer wall above the roof line., the typical construction practice test panel allowed water to penetrate between the roof/wall interface. the amount of water exiting the weeps was nearly identical between the irc and bia-southeast region details (comparing the 7:12 slopes). more water was absorbed by the brick for the irc test panel than the bia-southeast region test panel with equivalent slopes. this probably had to do with ....

Bob werner and jd smith install vinyl j channel at the roof -wall interface - a reese 59 second snapshot - video # ytv200b by john reese and uv concepts, roof wall interface sealing; entry door weather stripping; overhead door weather stripping; exhaust fan sealing; wall dense packing; we were later asked by the hospital to return and assist them in diagnosing an infiltration issue at the cancer center entrance. we were able to identify and remediate several problem areas without a disruption to the day to day activities at the hospital. why ....

This cannot be properly accomplished without removing the exterior wall covering. often the exterior wall covering is placed directly onto the surface of the roof when it must be a minimum 1 1/2" off the roof's surface. some manufacturers of exterior wall coverings require a minimum of 2" above the roof's surface.